ICROSS / SETUP

From bag to water

Unpack, inflate and set up. Follow the steps in order, then make one final check before heading out.

Start here→

1. 01

   Unpack and prepare

   Unroll the board on a flat, clean surface away from sharp objects. Set out the pump, fin and equipment included in your package.

   Open the valve cap. The valve button should be in its raised position for inflation. Connect the pump hose securely.

2. 02

   Inflate the board

   Inflate to the recommended working pressure: 7–10 PSI. Read the pump gauge and always follow the instructions for your model.

   Heat can raise the pressure and cold can lower it. Check before use. Disconnect the hose and close the valve cap.

   

3. 03

   Fit the fin

   Carefully turn the board over on a clean surface. Slide the fin into its track and secure the locking mechanism.

   Check that the fin is secure before turning the board back. Avoid putting weight on the fin or dragging it along the ground.

   

   

4. 04

   Set up the chair and paddle

   If your package includes a chair, unfold it, position it at the chair attachment points and secure the straps to the D-rings. Tighten evenly and check that the chair is stable.

   Assemble the paddle and check that its connections lock. Attach the paddle leash to the designated D-ring. Accessories vary between packages.

   

   

   

   

5. 05

   Check and launch

   Check the pressure, valve cap, fin lock and attachments. Secure loose equipment and put on your buoyancy aid.

   Carry the board to the water. Choose a calm, sheltered launch spot with enough depth for the fin.

This guide is an overview. Always follow the instructions supplied with your model and accessories.